2019 GMC Yukon recalls and common problems
Safety recalls and owner complaints from NHTSA.
2019 GMC Yukon recalls
2 safety recalls, newest first.
May2026Transfer case (4-wheel drive)Do not drivePower train · Campaign #26V289000
- The problem
- General Motors, LLC (GM) is recalling certain 2026 Cadillac Escalade and Escalade ESV, Chevrolet Silverado 1500, Suburban, and Tahoe, and GMC Sierra 1500, Yukon, and Yukon XL vehicles with four-wheel (4WD) or all-wheel drive (AWD), and certain 2015-2020 Suburban, Escalade, Escalade ESV, Yukon, Yukon XL, and Tahoe vehicles. A component missing from the drivetrain transfer case may cause the front and/or rear wheels to lock up without warning to the driver.
- The risk
- Front or rear wheel lockup increases the risk of a crash.
- The fix
- Owners are advised not to drive their vehicle until the remedy is completed. Dealers will inspect and, if necessary, replace the transfer case assembly, free of charge. Owner notification letters were mailed May 18, 2026. Owners may contact GMC customer service at 1-800-462-8782, Chevrolet customer service at 1-800-222-1020 or Cadillac customer service at 1-800-333-4223. GM's number for this recall is N262557620. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov on May 7, 2026.
Oct2019Wheel speed sensor/tone ringService brakes, hydraulic › Antilock/traction control/electronic limited slip · Campaign #19V761000
- The problem
- General Motors LLC (GM) is recalling certain 2015-2020 Chevrolet Suburban, Tahoe, and GMC Yukon, and 2014-2018 Chevrolet Silverado 1500 and GMC Sierra 1500 vehicles equipped with a 5.3-liter engine, a 3.08-ratio rear axle and four-wheel drive. If a wheel-speed sensor fails, while the vehicle is traveling between 41 and 60 mph in four-wheel or automatic mode, the Electronic-Brake Control Module (EBCM) software may activate the driveline-protection system.
- The risk
- Unintended activation of the driveline-protection system will cause unintended braking on the wheel on the opposite side of the failed sensor, causing the vehicle to pull to one side unexpectedly, increasing the risk of a crash.
- The fix
- GM will notify owners, and dealers will reprogram the EBCM, free of charge. The recall began December 11, 2019. Owners may contact Chevrolet customer service at 1-800-630-2438 or GMC customer service at 1-800-462-8782. GM's number for this recall is N192261050.
A recall may cover only some vehicles. Check whether yours has an open recall with its 17-character VIN. Recall repairs are free.
Check my VIN2019 GMC Yukon common problems
58 complaints filed by owners with NHTSA.
The parts owners report most and 1 a fire. These are owners' own reports, not confirmed defects, but they show where problems cluster.
Latest owner reports
The contact owns a 2019 GMC Yukon. The contact stated that while driving 25 MPH, there was an abnormal sound coming from under the hood. The contact stated that the sound became louder. The contact became aware of smoke coming from underneath the hood. The vehicle was taken to the dealer where it was diagnosed with engine failure. The contact was informed that the engine needed to be replaced.…
During normal acceleration on the interstate entrance ramp, the vehicle stuttered and continued on seemingly without issue. Within a few minutes, I noticed the check engine light flashing and fluctuating oil pressure, and I drove cautiously to the closest mechanic shop a few miles away. The code (P0307) indicated a cylinder 7 misfire, and I was referred to the dealership for further diagnostics.…
The contact owns a 2019 GMC Yukon. While driving approximately 65 - 70 MPH, the brake pedal was depressed; however, the vehicle failed to stop immediately. The brake assist warning light was illuminated. The vehicle was taken to an independent mechanic, who replaced the front brake pads and rotors; however, the failure persisted. The contact associated the failure with Special Coverage…
Lifters failed
Yukon would not idle without turning off on its own. Check engine light came on. Took it to my mechanic. Check engine light was flashing which indicated an active misfire. A running compression test found little to no compression from cylinder 6. Further investigation found that cylinder 5 had been repaired in 2022. Mechanic recommends engine replacement.
Source: NHTSA Office of Defects Investigation. Data downloaded Nov 22, 2026.