2016 Mazda Mazda6 recalls and common problems
Safety recalls and owner complaints from NHTSA.
2016 Mazda Mazda6 recalls
1 safety recall, newest first.
Aug2017Electric power assist systemSteering · Campaign #17V546000
- The problem
- Mazda North American Operations (Mazda) is recalling certain 2016 Mazda6 vehicles. Debris from the welding process during manufacturing of the front passenger seat frame may damage the occupant classification system (OCS) wiring.
- The risk
- If the wiring becomes damaged, there may be a loss of power steering assist and the deactivation of the passenger air bag, increasing the risk of a crash and the risk of injury in the event of a crash.
- The fix
- Mazda will notify owners, and dealers will attach a protective pad on the seat frame. If the OCS harness is damaged, insulating tape will be applied to the harness. These repairs will be performed free of charge. The recall began October 26, 2017. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 1517H.
A recall may cover only some vehicles. Check whether yours has an open recall with its 17-character VIN. Recall repairs are free.
Check my VIN2016 Mazda Mazda6 common problems
78 complaints filed by owners with NHTSA.
The parts owners report most; 9 reports involve a crash. These are owners' own reports, not confirmed defects, but they show where problems cluster.
Latest owner reports
All of the warning lights on my dashboard light up and beep sporadically. The vehicle stalls when I blow the horn or use the left turn signal, which is extremely dangerous on the freeway. The power steering occasionally fails. I took the vehicle to two service shops to have a diagnostic run and they both said that the code indicated that I would have to take the vehicle to the dealer. I checked…
The contact owns a 2016 Mazda Mazda6. The contact stated that while driving at an undisclosed speed, a burning odor was noticed inside the vehicle. No warning lights illuminated. The vehicle was taken to an independent mechanic, where it was diagnosed that the clutch disc kit had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure, and a…
The front CV axles on my car have failed. It begun with a clicking noise and vibration when accelerating. I took the car to the Mazda dealership, and they confirmed the sounds but said they weren't able to diagnose the issue and that I would have to leave my car for them to figure it out. This places my daughter and my life at risk, as well as other passengers, due to the critical role the CV…
The vehicle exhibits dangerous electronic malfunctions. A licensed technician (MV-113255) has confirmed a sporadic unintended acceleration defect where the cruise control 'decrease' button causes the vehicle to increase speed. Additionally, the vehicle repeatedly enters 'Limp Mode' in active traffic, causing a violent jerk and a total loss of acceleration while displaying a 'Smart City Brake…
The contact owns a 2016 Mazda Mazda6. The contact stated that after her husband had driven for approximately 2 hours with the seat heater activated, the passengerâs side seat overheated, and the seat started smoking. The driver stated that the seat heating element overheated and burned a hole in the seat, damaging the air bag located near the seat heater sensor. The dealer was contacted, and an…
Source: NHTSA Office of Defects Investigation. Data downloaded Nov 22, 2026.